I always have been fascinated by photography.
But with the introduction of the digital camera it all became too easy, too predictable …to me.
So I forced myself to go back to the roots of real analog photography.
Not just by making the photograph itself, but by controlling the entire photographic process.
This brought me back to the middle of the 19th century, to the amazing Collodion wet plate process.
And every single day I feel challenged to refine and improve myself.
For my website please visit : www.alextimmermans.com
"You don't take a picture, it's given to you"
maandag 25 juli 2011
I bought it, but it turned out to be too big to bring it up using the staircases.
( my studio is at my attic and also my dark room).
First i had to cut of the top. But with the right tools that wasn't such a big job.
Using a ladder we were able to get it in trough our bedroom window.
Just one staircase to go, but with just a small damage at the staircase we finally made it !!
Now i have to break down my old sink and replace it.
I hope starting to make 20 x 20 inch plates soon.
donderdag 14 juli 2011
While developing plates it was more difficult to spread the developer over the plates
So it was time to start maintenance on my silver bath.
As i did not have any other problems I decided just to boil the solution back to a volume of about 90%. After I done this several times now I found out there is no need to boil the volume back to a low level. Just boiling it to about 10% less of the original volume is ok. It 's only needed to get rid of the alcohol and ether.
After doing this I add the needed volume demi water and the bath can turn VERY cloudy.
Don't worry about that. Just shake the bottleand leave it that way for a few hours it will clear and you will see a lot of dirt at the bottom of the bottle
After that I sunned the bath under a face tanner. filtered it twice, checked gravity, added the needed silver nitrate and it was ready for use again
Result : a perfectly clear and good working silver bath again.
So it takes a few hours but the result is worth it.
maandag 11 juli 2011
Actually, i like it a lot. Love the smell.........
First you need to get sandarac.
Sandarac (or sandarach) is a resin obtained from the small cypress-like tree Tetraclinis articulata.
Because it contains lots of dirt. I once had an ant in my bottle , you need to filter it very very good.
There is no need to crush the small pieces as it dissolves quite easy in alcohol.
Just measure the needed quantity and drop it in a bottle with the right volume of alcohol.
You can leave it like that for a day or so or take the bottle and shake it several times during watching TV.....
When the resin has dissolved you will have a very cloudy solution which needs to be filtered.
For the first 2 times you can just use normal coffee filters.
You will see the difference as it becomes clearer and clearer after each filtering.
After using the coffee filter i always use laboratory folding micro filters.
After filtering it twice again you will obtain a very clear yellow solution and it is ready as a base.
You will only have to add the needed volume lavender oil to finish this job.